How To Replace The Motor Of Piezoelectric Photographer

- Aug 29, 2019-

As we all know, the motor is the core of the power of the photo machine. Whether the photo machine works properly or not, the good or bad of the motor plays a very important role. The life of the motor is very long and it is not easy to damage, so we must first determine whether the motor is damaged before replacing it. For example, we must open the cover of the motor to observe whether the motor is rotating or not, because the problems of belt damage and gear occlusion will also lead to car and paper failure. _


It is determined that the motor problem can be replaced according to the following steps:


1. Disconnect the power supply and use a screwdriver to remove the cover of the photo machine.  


2. Unload the connection of the motor. Before unplugging the connection, you must remember where it was originally connected. Otherwise, the wrong connection will have the risk of burning the motor and causing damage to the motherboard.  


3. Take off the drive belt, and pay attention to the process. Do not use too much force to injure the motor.  


4. Remove the old motor and install the new one.  


The installation process must be noted that the whole process can be completed with a screwdriver, can not use hammer or other knocking, because the photo machine is a sophisticated equipment, if received impact will likely cause secondary damage to the photo machine.