Daily Maintenance Of Ink Stack And Scraper Of Outdoor Photo Machine

- Feb 24, 2020-

First of all, we understand the function of the ink stack of the outdoor photo machine. The ink stack is one of the important parts of the photo machine. Its main responsibility is to carry the nozzle. When the machine is not used for a long time after stopping, the nozzle of the photo machine will stay on the ink stack, so as to effectively prevent the blockage caused by the ink condensation on the surface of the nozzle.  


1. The ink guide groove of the ink stack shall also be cleaned every day.  


2. For the daily cleaning and maintenance of the blade, the cotton swab can be used to wipe it with cleaning solution, and the ink accumulation in the blade slide and the ink accumulation guide groove can be cleaned, so as to reduce the resistance of the movement before and after the blade.  


3. Before the machine is shut down every day, it is recommended to drip cleaning liquid into the cap of the ink stack to clean the waste ink pipe and prevent the waste ink pipe from blocking. (this should be done every day to extend the service life of the ink stack)


4. The ink on the protection plates on both sides of the nozzle should also be cleaned every day to prevent the ink from rubbing the paper during printing.  


In addition, for outdoor photo machine, the weak solvent ink has certain volatility, and the machine is not easy to plug for a long time. Please pay attention to the maintenance of the ink path of the machine. Before using the photo machine every day, it is recommended to print the nozzle test strip to check whether the nozzle is blocked. If it is blocked, please carry out cleaning operation to ensure that the nozzle is in good condition.


During the maintenance, first pay attention to the power-off operation of the machine, do not operate with electricity. Before the shutdown, please drop a special cleaning solution into the ink stack cap, do a cleaning, and then print a test strip to check to ensure that the nozzle status is normal. Then place the car in the ink stack, place the nozzle height in the low gear, and shut down normally.