Heater Tips for using piezoelectric photo machine

- Jan 21, 2019-

Due to weather conditions or work environment of piezoelectric pictorial machine appear difficult to dry, even in the output picture spread and so on problems, you again in the heating function for how to good use machines and entangled with the worry, in fact the use of the heater mainly depends on the environment temperature and humidity, the machine working environment temperature of 18 ℃ ~ 25 ℃, humidity 70%, for a friend without standard installation of air conditioning and humidifier device, is below small make up according to the season, the environmental situation separately various machines and the use of the heater tip:


Indoor photo machine


Some piezoelectric pictorial machine equipment with no heating device, need to buy another external heater, this situation is suggested to play figure 10 minutes in advance before open heater, set the heating temperature of 50 ℃ ~ 55 ℃, more than 55 ℃, many materials can be baked deformation, the effect of failed. It is suggested that in addition to the infrared heater, an external medium wave tube heater should be selected to improve the drying efficiency. The medium wave tube heater is a knob type drying efficiency adjustment device. It is recommended to increase the drying strength as far as possible without baking deformed materials.  


Outdoor photo machine


Lecai pictorial machine standard after the three sections of heating in the former, this situation is suggested to play figure 10 minutes in advance before open heater, heating temperature Settings: the heat setting temperature below 30 ℃, the temperature too high can lead to wriggle through the earth for paper material is too soft to walk or even walk and wipe nozzle, the car; Before heating 45 ℃ ~ 55 ℃; Infrared heater 50 ℃ ~ 55 ℃, more than 55 ℃, many materials can be baked deformation, the effect of failed.  


It is suggested to buy an external medium wave tube heater in addition to the infrared heater to improve the drying efficiency. The medium wave tube heater is a knob type drying efficiency adjustment device. It is recommended to increase the drying strength as far as possible on the premise of not baking deformed materials. Outdoor ink absorption performance of materials is highly affected by the environment temperature, if the environment temperature can't remain above 15 ℃, the likely spread heat fully open also can appear problem, then suggest that behind the machine increase external dryer heating temperature of the material in advance, improve ink absorption performance of materials, the heater temperature setting advice below 40 ℃, otherwise it will cause wriggle through the earth for paper material is too soft to walk or even walk and wipe nozzle, the car.